NETGEAR R8000P: OpenWrt Compatibility Report
The NETGEAR R8000P runs OpenWrt 24.10.4 on the bcm4908/generic target, and has been supported since 21.02.0. Its WiFi 5 (AC) wireless rates fair for open-source driver support (0.50/1.0), installation is rated easy, and it is still sold new.
Hardware data and retail listings last checked .
Where to buy
Some links are affiliate links. Learn more.
Specifications
| SoC | Broadcom BCM4906 |
|---|---|
| CPU | 2 cores @ 1800 MHz |
| RAM | 512 MB |
| Flash | 128 MB (NAND) |
| Ethernet ports | 5 |
| USB | 1x 2.0, 1x 3.0 |
| WiFi generation | WiFi 5 (AC) |
| Radios | 2.4GHz: b/g/n · 5GHz: a/n/ac |
| WLAN hardware | 2x Broadcom BCM4365E |
| OpenWrt target | bcm4908 / generic |
| Package architecture | aarch64_cortex-a53 |
| Current release | 24.10.4 |
| Supported since | 21.02.0 |
| Install method | CFE web recovery, see git-commit |
| Install difficulty | easy |
| Power supply | 19 VDC, 3.16A via barrel |
| Device type | Home router |
| Estimated throughput | 900 Mbps |
| Availability | available |
Installing OpenWrt on the R8000P
Installation on this device is rated easy. You can flash it from the stock web interface without opening the case or using a serial cable. Documented methods: CFE web recovery, see git-commit.
Official OpenWrt device page for the R8000P
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Other routers to consider
Ruckus R500
MikroTik RB962UiGS-5HacT2HnT (hAP ac)
Ubiquiti UniFi UK-Ultra
Not sure which fits? Take the 60-second quiz.