GL.iNet GL-AP1300 (Cirrus): OpenWrt Compatibility Report
The GL.iNet GL-AP1300 (Cirrus) runs OpenWrt 25.12.5 on the ipq40xx/generic target, and has been supported since 21.02.0. Its WiFi 5 (AC) wireless on the ath10k-ct driver rates good for open-source driver support (0.70/1.0), installation is rated easy, and it is no longer sold new.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the GL.iNet GL-AP1300 (Cirrus), which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | Qualcomm Atheros IPQ4018 |
|---|---|
| CPU | 4 cores @ 717 MHz |
| RAM | 256 MB |
| Flash | 128 MB (NAND) |
| Ethernet ports | 2 |
| WiFi generation | WiFi 5 (AC) |
| Radios | 2.4GHz: b/g/n · 5GHz: a/n/ac |
| WLAN hardware | Qualcomm Atheros IPQ4018 |
| WLAN driver | ath10k-ct |
| OpenWrt target | ipq40xx / generic |
| Package architecture | arm_cortex-a7_neon-vfpv4 |
| Current release | 25.12.5 |
| Supported since | 21.02.0 |
| Install method | U-Boot TFTP recovery, U-Boot web recovery, see git-commit |
| Install difficulty | easy |
| Power supply | 12 VDC, 2A via barrel, or PoE 802.3at |
| Device type | Access point |
| Estimated throughput | 501 Mbps |
| Availability | discontinued |
Installing OpenWrt on the GL-AP1300 (Cirrus)
Installation on this device is rated easy. You can flash it from the stock web interface without opening the case or using a serial cable. Documented methods: U-Boot TFTP recovery, U-Boot web recovery, see git-commit.
Official OpenWrt device page for the GL-AP1300 (Cirrus)
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
Ruckus R500
MikroTik RB962UiGS-5HacT2HnT (hAP ac)
Ubiquiti UniFi UK-Ultra
Not sure which fits? Take the 60-second quiz.