FriendlyARM NanoPC-T4: OpenWrt Compatibility Report
The FriendlyARM NanoPC-T4 runs OpenWrt 25.12.1 on the rockchip/armv8 target, and has been supported since 24.10.0. Its WiFi 5 (AC) wireless on the brcmfmac driver rates fair for open-source driver support (0.60/1.0), installation is rated moderate, and it is still sold new.
Hardware data and retail listings last checked .
Where to buy
Some links are affiliate links. Learn more.
Specifications
| SoC | Rockchip RK3399 |
|---|---|
| CPU | 6 cores @ 2000 MHz |
| RAM | 4096 MB |
| Ethernet ports | 1 |
| USB | 2x 2.0, 1x 3.0 |
| WiFi generation | WiFi 5 (AC) |
| Radios | 2.4GHz: b/g/n · 5GHz: a/n/ac |
| WLAN hardware | Broadcom BCM4356A2 (AMPAK AP6356S) |
| WLAN driver | brcmfmac |
| OpenWrt target | rockchip / armv8 |
| Package architecture | aarch64_generic |
| Current release | 25.12.1 |
| Supported since | 24.10.0 |
| Install method | SD card |
| Install difficulty | moderate |
| Power supply | 12 VDC, 2A via barrel |
| Device type | Access point |
| Estimated throughput | 1000 Mbps |
| Availability | available |
Installing OpenWrt on the NanoPC-T4
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: SD card.
Decompress then flash image to SD card
Official OpenWrt device page for the NanoPC-T4
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Other routers to consider
Ruckus R500
MikroTik RB962UiGS-5HacT2HnT (hAP ac)
Ubiquiti UniFi UK-Ultra
Not sure which fits? Take the 60-second quiz.