EnGenius EAP1300: OpenWrt Compatibility Report
The EnGenius EAP1300 runs OpenWrt 24.10.4 on the ipq40xx/generic target, and has been supported since 19.07.0. Its WiFi 5 (AC) wireless on the ath10k-ct driver rates good for open-source driver support (0.70/1.0), installation is rated moderate, and it is no longer sold new.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the EnGenius EAP1300, which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | Qualcomm Atheros IPQ4018 |
|---|---|
| CPU | 4 cores @ 717 MHz |
| RAM | 256 MB |
| Flash | 32 MB |
| Ethernet ports | 1 |
| WiFi generation | WiFi 5 (AC) |
| Radios | 2.4GHz: b/g/n · 5GHz: a/n/ac |
| WLAN hardware | Qualcomm Atheros IPQ4018 |
| WLAN driver | ath10k-ct |
| OpenWrt target | ipq40xx / generic |
| Package architecture | arm_cortex-a7_neon-vfpv4 |
| Current release | 24.10.4 |
| Supported since | 19.07.0 |
| Install method | U-Boot TFTP + serial recovery, see git-commit |
| Install difficulty | moderate |
| Power supply | 12 VDC, 1.0 A, PoE 802.3af |
| Device type | Access point |
| Estimated throughput | 501 Mbps |
| Availability | discontinued |
Installing OpenWrt on the EAP1300
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: U-Boot TFTP + serial recovery, see git-commit.
Official OpenWrt device page for the EAP1300
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
Ruckus R500
MikroTik RB962UiGS-5HacT2HnT (hAP ac)
Ubiquiti UniFi UK-Ultra
Not sure which fits? Take the 60-second quiz.