WatchGuard Firebox M300: OpenWrt Compatibility Report

WatchGuard Firebox M300 router
Image: OpenWrt Table of Hardware, CC BY-SA 4.0

The WatchGuard Firebox M300 runs OpenWrt 25.12.5 on the qoriq/generic target, and has been supported since 24.10.0. Its No WiFi wireless on the none driver rates fair for open-source driver support (0.50/1.0), installation is rated moderate, and it is no longer sold new.

Drivers: Fair (0.50) No WiFi Install: moderate

Hardware data and retail listings last checked .

Discontinued. This model is no longer sold new, so this page is kept as a reference for people who already own one. See current alternatives.

Where to buy

We have no current retail listing for the WatchGuard Firebox M300, which is no longer sold new. See current alternatives for devices you can still buy today.

Specifications

SoC NXP T2081
CPU 4 cores @ 1500 MHz
RAM 4096 MB
Flash 4 MB
Ethernet ports 8
USB 2x 2.0
WiFi generation No WiFi
WLAN hardware -
WLAN driver none
OpenWrt target qoriq / generic
Package architecture powerpc64_e5500
Current release 25.12.5
Supported since 24.10.0
Install method SD card, U-Boot TFTP recovery, U-Boot USB recovery, see devicepage, see git-commit
Install difficulty moderate
Power supply 100-240 VAC, 50/60Hz, 1.5A via C13
Device type Home router
Estimated throughput 1000 Mbps
Availability discontinued

Installing OpenWrt on the Firebox M300

Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: SD card, U-Boot TFTP recovery, U-Boot USB recovery, see devicepage, see git-commit.

Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.

Still sold and well supported

Deciso DEC740

No WiFi Drivers: Good

Mellanox Spectrum SN3420

No WiFi Drivers: Good $24974

Mellanox Spectrum SN2700

No WiFi Drivers: Good $7995

Not sure which fits? Take the 60-second quiz.