T-Com / Telekom Speedport W 504V: OpenWrt Compatibility Report
The T-Com / Telekom Speedport W 504V runs OpenWrt 24.10.4 on the lantiq/xway target, and has been supported since 17.01.0. Its WiFi 4 (N) wireless on the ath9k driver rates fair for open-source driver support (0.50/1.0), installation is rated moderate, and it is no longer sold new.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the T-Com / Telekom Speedport W 504V, which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | Lantiq DANUBE (PSB 50702) |
|---|---|
| CPU | 2 cores @ 333 MHz |
| RAM | 64 MB |
| Flash | 8 MB |
| Ethernet ports | 4 |
| USB | 1x 2.0 |
| WiFi generation | WiFi 4 (N) |
| Radios | 2.4GHz: b/g/n · 5GHz: a/n |
| WLAN hardware | Atheros AR9220 |
| WLAN driver | ath9k |
| OpenWrt target | lantiq / xway |
| Package architecture | mips_24kc |
| Current release | 24.10.4 |
| Supported since | 17.01.0 |
| Install method | see devicepage |
| Install difficulty | moderate |
| Power supply | 12V, 1.25A via barrel |
| Device type | Home router |
| Estimated throughput | 83 Mbps |
| Availability | discontinued |
Installing OpenWrt on the Speedport W 504V
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: see devicepage.
Official OpenWrt device page for the Speedport W 504V
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
GL.iNet GL-X300B (Collie)
KuWFi CPE830(D)
YunCore CPE830(D)
Not sure which fits? Take the 60-second quiz.