SolidRun CuBox i4x4: OpenWrt Compatibility Report
The SolidRun CuBox i4x4 runs OpenWrt 24.10.4 on the imx/cortexa9 target, and has been supported since 19.07.0. Its WiFi 4 (N) wireless on the brcmfmac driver rates fair for open-source driver support (0.50/1.0), installation is rated moderate, and it is no longer sold new.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the SolidRun CuBox i4x4, which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | NXP i.MX6 Quad |
|---|---|
| CPU | 4 cores @ 1000 MHz |
| RAM | 4096 MB |
| Ethernet ports | 1 |
| USB | 2x 2.0 |
| WiFi generation | WiFi 4 (N) |
| Radios | 2.4GHz: b/g/n |
| WLAN hardware | Broadcom BCM4329 |
| WLAN driver | brcmfmac |
| OpenWrt target | imx / cortexa9 |
| Package architecture | arm_cortex-a9_neon |
| Current release | 24.10.4 |
| Supported since | 19.07.0 |
| Install method | SD card, see git-commit |
| Install difficulty | moderate |
| Power supply | 5 VDC, 3.0A |
| Device type | Access point |
| Estimated throughput | 700 Mbps |
| Availability | discontinued |
Installing OpenWrt on the CuBox i4x4
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: SD card, see git-commit.
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
GL.iNet GL-X300B (Collie)
KuWFi CPE830(D)
YunCore CPE830(D)
Not sure which fits? Take the 60-second quiz.