SolidRun CuBox i2: OpenWrt Compatibility Report
The SolidRun CuBox i2 runs OpenWrt 24.10.4 on the imx/cortexa9 target, and has been supported since 19.07.0. Its No WiFi wireless on the none driver rates fair for open-source driver support (0.50/1.0), installation is rated moderate, and it is no longer sold new.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the SolidRun CuBox i2, which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | NXP i.MX6 Dual Lite |
|---|---|
| CPU | 2 cores @ 1000 MHz |
| RAM | 1024 MB |
| Ethernet ports | 1 |
| USB | 2x 2.0 |
| WiFi generation | No WiFi |
| WLAN hardware | - |
| WLAN driver | none |
| OpenWrt target | imx / cortexa9 |
| Package architecture | arm_cortex-a9_neon |
| Current release | 24.10.4 |
| Supported since | 19.07.0 |
| Install method | SD card, see git-commit |
| Install difficulty | moderate |
| Power supply | 5 VDC, 2.0A |
| Device type | Single-board computer |
| Estimated throughput | 350 Mbps |
| Availability | discontinued |
Installing OpenWrt on the CuBox i2
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: SD card, see git-commit.
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
Deciso DEC740
Mellanox Spectrum SN3420
Mellanox Spectrum SN2700
Not sure which fits? Take the 60-second quiz.