SolidRun ClearFog CN9130 Pro: OpenWrt Compatibility Report
The SolidRun ClearFog CN9130 Pro runs OpenWrt 24.10.5 on the mvebu/cortexa72 target, and has been supported since 24.10.0. Its No WiFi wireless on the none driver rates fair for open-source driver support (0.50/1.0), installation is rated moderate, and it is still sold new.
Hardware data and retail listings last checked .
Where to buy
Some links are affiliate links. Learn more.
Specifications
| SoC | Marvell OCTEON CN9130 |
|---|---|
| CPU | 4 cores @ 2000 MHz |
| RAM | 4096 MB |
| Flash | 8 MB |
| Ethernet ports | 6 |
| USB | 1x 3.0 |
| WiFi generation | No WiFi |
| WLAN hardware | - |
| WLAN driver | none |
| OpenWrt target | mvebu / cortexa72 |
| Package architecture | aarch64_cortex-a72 |
| Current release | 24.10.5 |
| Supported since | 24.10.0 |
| Install method | see git-commit |
| Install difficulty | moderate |
| Power supply | 9-32 VDC via barrel, PoE header |
| Device type | Wired only |
| Estimated throughput | 1000 Mbps |
| Availability | available |
Installing OpenWrt on the ClearFog CN9130 Pro
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: see git-commit.
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Other routers to consider
Deciso DEC740
Mellanox Spectrum SN3420
Mellanox Spectrum SN2700
Not sure which fits? Take the 60-second quiz.