Sinovoip Banana Pi P2 Zero: OpenWrt Compatibility Report
The Sinovoip Banana Pi P2 Zero runs OpenWrt 25.12.1 on the sunxi/cortexa7 target, and has been supported since 24.10.0. Its WiFi 4 (N) wireless on the brcmfmac driver rates fair for open-source driver support (0.50/1.0), installation is rated moderate, and it is still sold new.
Hardware data and retail listings last checked .
Where to buy
Some links are affiliate links. Learn more.
Specifications
| SoC | Allwinner H2+ |
|---|---|
| CPU | 4 cores @ 1000 MHz |
| RAM | 512 MB |
| Ethernet ports | 1 |
| USB | 1x 2.0 |
| WiFi generation | WiFi 4 (N) |
| Radios | 2.4GHz: b/g/n |
| WLAN hardware | AMPAK AP6212 (Broadcom BCM43430) |
| WLAN driver | brcmfmac |
| OpenWrt target | sunxi / cortexa7 |
| Package architecture | arm_cortex-a7_neon-vfpv4 |
| Current release | 25.12.1 |
| Supported since | 24.10.0 |
| Install method | see git-commit |
| Install difficulty | moderate |
| Power supply | 5V/2A USB Female Micro-B or optional 802.3af PoE |
| Device type | Access point |
| Estimated throughput | 700 Mbps |
| Availability | available |
Installing OpenWrt on the Banana Pi P2 Zero
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: see git-commit.
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Other routers to consider
GL.iNet GL-X300B (Collie)
KuWFi CPE830(D)
YunCore CPE830(D)
Not sure which fits? Take the 60-second quiz.