NETGEAR WNR854T: OpenWrt Compatibility Report
The NETGEAR WNR854T was supported by OpenWrt from 10.03 on the orion/generic target, but its last supported release has reached end of life. Its WiFi 4 (N) wireless on the mwlwifi driver rates fair for open-source driver support (0.50/1.0), installation is rated easy, and it is no longer sold new.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the NETGEAR WNR854T, which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | Marvell 88F5180NB1 |
|---|---|
| CPU | 1 core @ 500 MHz |
| RAM | 32 MB |
| Flash | 8 MB |
| Ethernet ports | 5 |
| WiFi generation | WiFi 4 (N) |
| Radios | 2.4GHz: b/g/n |
| WLAN hardware | Marvell 88W8361 (mini-PCI Gemtek WMIM-205GN) |
| WLAN driver | mwlwifi |
| OpenWrt target | orion / generic |
| Package architecture | arm_xscale |
| Current release | EOL |
| Supported since | 10.03 |
| Install method | GUI OEM, U-Boot TFTP + serial recovery, see devicepage |
| Install difficulty | easy |
| Power supply | 12 VDC, 1.5A |
| Device type | Home router |
| Estimated throughput | 87 Mbps |
| Availability | discontinued |
Installing OpenWrt on the WNR854T
Installation on this device is rated easy. You can flash it from the stock web interface without opening the case or using a serial cable. Documented methods: GUI OEM, U-Boot TFTP + serial recovery, see devicepage.
Official OpenWrt device page for the WNR854T
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
GL.iNet GL-X300B (Collie)
KuWFi CPE830(D)
YunCore CPE830(D)
Not sure which fits? Take the 60-second quiz.