NETGEAR WNR834B: OpenWrt Compatibility Report
The NETGEAR WNR834B was supported by OpenWrt from 12.09 on the bcm47xx/legacy target, but its last supported release has reached end of life. Its WiFi 4 (N) wireless on the b43 driver rates limited for open-source driver support (0.35/1.0), installation is rated moderate, and it is no longer sold new. Its wireless does not work correctly under OpenWrt, so it is listed here for reference rather than as a recommendation.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the NETGEAR WNR834B, which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | Broadcom BCM4704KFBG |
|---|---|
| CPU | 1 core @ 264 MHz |
| RAM | 16 MB |
| Flash | 4 MB |
| Ethernet ports | 5 |
| WiFi generation | WiFi 4 (N) |
| Radios | 2.4GHz: b/g/n |
| WLAN hardware | Broadcom BCM4321, Broadcom BCM2055 |
| WLAN driver | b43 |
| OpenWrt target | bcm47xx / legacy |
| Package architecture | mipsel_mips32 |
| Current release | EOL |
| Supported since | 12.09 |
| Install difficulty | moderate |
| Power supply | 12 VDC, 1.0A |
| Device type | Home router |
| Estimated throughput | 33 Mbps |
| Availability | discontinued |
Installing OpenWrt on the WNR834B
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload.
Official OpenWrt device page for the WNR834B
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
GL.iNet GL-X300B (Collie)
KuWFi CPE830(D)
YunCore CPE830(D)
Not sure which fits? Take the 60-second quiz.