NETGEAR WAG302: OpenWrt Compatibility Report
The NETGEAR WAG302 was supported by OpenWrt from 12.09 on the ixp4xx/generic target, but its last supported release has reached end of life. It has no wireless radio, and its open-source driver support rates fair (0.50/1.0), installation is rated moderate, and it is no longer sold new.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the NETGEAR WAG302, which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | Intel IXP422BB |
|---|---|
| CPU | 1 core @ 266 MHz |
| RAM | 16 MB |
| Flash | 8 MB |
| Ethernet ports | 1 |
| WiFi generation | Pre-WiFi 4 (802.11a/b/g) |
| Radios | 2.4GHz: b/g · 5GHz: a |
| OpenWrt target | ixp4xx / generic |
| Package architecture | armeb_xscale |
| Current release | EOL |
| Supported since | 12.09 |
| Install method | see devicepage |
| Install difficulty | moderate |
| Power supply | 12 VDC, 1.2A |
| Device type | Access point |
| Estimated throughput | 46 Mbps |
| Availability | discontinued |
Installing OpenWrt on the WAG302
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: see devicepage.
Official OpenWrt device page for the WAG302
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Hardware versions
The WAG302 ships in several hardware revisions with different chipsets. Match the version printed on your device label before flashing.
| Version | Target | Current release | WLAN hardware |
|---|---|---|---|
| V2 shown above | ixp4xx/generic | EOL | - |
| V1 | ixp4xx/generic | EOL | Z-Com XA-621 (Atheros AR5212A mini-PCI), Z-Com XG-621 (Atheros AR5212A mini-PCI) |
Still sold and well supported
Sinovoip Banana Pi BPI-R4
Sinovoip Banana Pi BPi-R3 Mini
Huasifei WH3000
Not sure which fits? Take the 60-second quiz.