NETGEAR GS308T: OpenWrt Compatibility Report
The NETGEAR GS308T runs OpenWrt 25.12.1 on the realtek/rtl838x target, and has been supported since 22.03.0. Its No WiFi wireless on the none driver rates fair for open-source driver support (0.50/1.0), installation is rated easy, and it is no longer sold new.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the NETGEAR GS308T, which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | Realtek RTL8380M |
|---|---|
| CPU | 1 core @ 500 MHz |
| RAM | 128 MB |
| Flash | 32 MB |
| Ethernet ports | 8 |
| WiFi generation | No WiFi |
| WLAN driver | none |
| OpenWrt target | realtek / rtl838x |
| Package architecture | mips_4kec |
| Current release | 25.12.1 |
| Supported since | 22.03.0 |
| Install method | GUI OEM, U-Boot TFTP recovery |
| Install difficulty | easy |
| Power supply | 12 VDC, 1.0A |
| Device type | Wired only |
| Estimated throughput | 62 Mbps |
| Availability | discontinued |
Installing OpenWrt on the GS308T
Installation on this device is rated easy. You can flash it from the stock web interface without opening the case or using a serial cable. Documented methods: GUI OEM, U-Boot TFTP recovery.
Flash initramfs-kernel image to slot "Image 1" and reboot, then use sysupgrade to install a sysupgrade image permanently.
Official OpenWrt device page for the GS308T
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
Deciso DEC740
Mellanox Spectrum SN3420
Mellanox Spectrum SN2700
Not sure which fits? Take the 60-second quiz.