MikroTik RBSXT2nDr3 (SXT Lite 2): OpenWrt Compatibility Report
The MikroTik RBSXT2nDr3 (SXT Lite 2) was supported by OpenWrt from 19.07.0 on the ar71xx/mikrotik target, but its last supported release has reached end of life. Its WiFi 4 (N) wireless on the ath9k driver rates fair for open-source driver support (0.50/1.0), installation is rated moderate, and it is no longer sold new.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the MikroTik RBSXT2nDr3 (SXT Lite 2), which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | Atheros AR9344 |
|---|---|
| CPU | 1 core @ 600 MHz |
| RAM | 64 MB |
| Flash | 16 MB |
| Ethernet ports | 1 |
| WiFi generation | WiFi 4 (N) |
| Radios | 2.4GHz: b/g/n |
| WLAN driver | ath9k |
| OpenWrt target | ar71xx / mikrotik |
| Package architecture | mips_24kc |
| Current release | EOL |
| Supported since | 19.07.0 |
| Install method | Mikrotik TFTP, see git-commit |
| Install difficulty | moderate |
| Power supply | Passive PoE 8-30 VDC, 6W |
| Device type | Access point |
| Estimated throughput | 75 Mbps |
| Availability | discontinued |
Installing OpenWrt on the RBSXT2nDr3 (SXT Lite 2)
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: Mikrotik TFTP, see git-commit.
Erase the firmware MTD partition. Use sysupgrade -F (force)
Official OpenWrt device page for the RBSXT2nDr3 (SXT Lite 2)
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
GL.iNet GL-X300B (Collie)
KuWFi CPE830(D)
YunCore CPE830(D)
Not sure which fits? Take the 60-second quiz.