Lemaker Banana Pro: OpenWrt Compatibility Report
The Lemaker Banana Pro runs OpenWrt 25.12.1 on the sunxi/cortexa7 target, and has been supported since 15.05. Its WiFi 4 (N) wireless on the brcmfmac driver rates fair for open-source driver support (0.50/1.0), installation is rated moderate, and it is no longer sold new.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the Lemaker Banana Pro, which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | Allwinner A20 |
|---|---|
| CPU | 2 cores @ 1000 MHz |
| RAM | 1024 MB |
| Ethernet ports | 1 |
| USB | 2x 2.0, 1x OTG |
| WiFi generation | WiFi 4 (N) |
| Radios | 2.4GHz: b/g/n |
| WLAN hardware | Broadcom BCM43362 |
| WLAN driver | brcmfmac |
| OpenWrt target | sunxi / cortexa7 |
| Package architecture | arm_cortex-a7_neon-vfpv4 |
| Current release | 25.12.1 |
| Supported since | 15.05 |
| Install method | see devicepage |
| Install difficulty | moderate |
| Power supply | 5 VDC, 2.0 A via USB Female Micro-B |
| Device type | Access point |
| Estimated throughput | 350 Mbps |
| Availability | discontinued |
Installing OpenWrt on the Banana Pro
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: see devicepage.
Official OpenWrt device page for the Banana Pro
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
GL.iNet GL-X300B (Collie)
KuWFi CPE830(D)
YunCore CPE830(D)
Not sure which fits? Take the 60-second quiz.