Iomega ix4-200d: OpenWrt Compatibility Report
The Iomega ix4-200d runs OpenWrt 25.12.5 on the kirkwood/generic target, and has been supported since 23.05.0. Its No WiFi wireless on the none driver rates fair for open-source driver support (0.50/1.0), installation is rated moderate, and it is no longer sold new.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the Iomega ix4-200d, which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | Marvell 88F6281 |
|---|---|
| CPU | 1 core @ 1200 MHz |
| RAM | 512 MB |
| Flash | 32 MB |
| Ethernet ports | 2 |
| USB | 3x 2.0 |
| WiFi generation | No WiFi |
| WLAN hardware | - |
| WLAN driver | none |
| OpenWrt target | kirkwood / generic |
| Package architecture | arm_xscale |
| Current release | 25.12.5 |
| Supported since | 23.05.0 |
| Install method | U-Boot TFTP + serial recovery |
| Install difficulty | moderate |
| Power supply | 19 VDC, 4.74 A |
| Device type | Wired only |
| Estimated throughput | 210 Mbps |
| Availability | discontinued |
Installing OpenWrt on the ix4-200d
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: U-Boot TFTP + serial recovery.
Official OpenWrt device page for the ix4-200d
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
Deciso DEC740
Mellanox Spectrum SN3420
Mellanox Spectrum SN2700
Not sure which fits? Take the 60-second quiz.