Intellidesign Hyrax PCP-100: OpenWrt Compatibility Report
The Intellidesign Hyrax PCP-100 was supported by OpenWrt from 14.07 on the at91/sama5d3 target, but its last supported release has reached end of life. Its WiFi 4 (N) wireless rates fair for open-source driver support (0.50/1.0), installation is rated moderate, and we have no current US retail listing for it.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the Intellidesign Hyrax PCP-100, which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | Atmel ATSAMA5D35 |
|---|---|
| CPU | 1 core @ 536 MHz |
| RAM | 256 MB |
| Flash | 256 MB (NAND) |
| Ethernet ports | 2 |
| USB | Yes |
| WiFi generation | WiFi 4 (N) |
| Radios | 2.4GHz: b/g/n |
| WLAN hardware | CSR WF111 |
| OpenWrt target | at91 / sama5d3 |
| Package architecture | arm_cortex-a5_vfpv4 |
| Current release | EOL |
| Supported since | 14.07 |
| Install method | see devicepage |
| Install difficulty | moderate |
| Device type | Home router |
| Estimated throughput | 93 Mbps |
| Availability | not_available |
Installing OpenWrt on the Hyrax PCP-100
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: see devicepage.
Official OpenWrt device page for the Hyrax PCP-100
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
GL.iNet GL-X300B (Collie)
KuWFi CPE830(D)
YunCore CPE830(D)
Not sure which fits? Take the 60-second quiz.