i.onik Cloud Hub: OpenWrt Compatibility Report
The i.onik Cloud Hub was supported by OpenWrt from external image on the ramips/rt305x target, but its last supported release has reached end of life. Its WiFi 4 (N) wireless on the rt2800pci driver rates fair for open-source driver support (0.50/1.0), installation is rated moderate, and it is no longer sold new.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the i.onik Cloud Hub, which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | Ralink RT5350 |
|---|---|
| CPU | 1 core @ 360 MHz |
| RAM | 64 MB |
| Flash | 8 MB |
| USB | 1x 2.0 |
| WiFi generation | WiFi 4 (N) |
| Radios | 2.4GHz: b/g/n |
| WLAN hardware | Ralink RT2820 |
| WLAN driver | rt2800pci |
| OpenWrt target | ramips / rt305x |
| Package architecture | mipsel_24kc |
| Current release | EOL |
| Supported since | external image |
| Install method | Serial, Telnet |
| Install difficulty | moderate |
| Power supply | 5 VDC (µUSB), 1900 mAh battery |
| Device type | Travel router |
| Estimated throughput | 45 Mbps |
| Availability | discontinued |
Installing OpenWrt on the Cloud Hub
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: Serial, Telnet.
login root/91657853, then mtd_write of sysupgrade image to mtd5
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
GL.iNet GL-X300B (Collie)
KuWFi CPE830(D)
YunCore CPE830(D)
Not sure which fits? Take the 60-second quiz.