H3C Magic NX30 Pro: OpenWrt Compatibility Report
The H3C Magic NX30 Pro runs OpenWrt 25.12.1 on the mediatek/filogic target, and has been supported since 23.05.0. Its WiFi 6 (AX) wireless on the mt76 driver rates excellent for open-source driver support (0.95/1.0), installation is rated moderate, and we have no current US retail listing for it.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the H3C Magic NX30 Pro, which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | MediaTek MT7981BA |
|---|---|
| CPU | 2 cores @ 1300 MHz |
| RAM | 256 MB |
| Flash | 128 MB (NAND) |
| Ethernet ports | 4 |
| WiFi generation | WiFi 6 (AX) |
| Radios | 2.4GHz: b/g/n/ax · 5GHz: a/n/ac/ax |
| WLAN hardware | MediaTek MT7976C |
| WLAN driver | mt76 |
| OpenWrt target | mediatek / filogic |
| Package architecture | aarch64_cortex-a53 |
| Current release | 25.12.1 |
| Supported since | 23.05.0 |
| Install method | U-Boot TFTP recovery |
| Install difficulty | moderate |
| Power supply | 12V/1A via barrel |
| Device type | Home router |
| Estimated throughput | 650 Mbps |
| Availability | not_available |
Installing OpenWrt on the Magic NX30 Pro
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: U-Boot TFTP recovery.
Official OpenWrt device page for the Magic NX30 Pro
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
Sinovoip Banana Pi BPi-R3 Mini
Huasifei WH3000
GL.iNet GL-MT6000 (Flint 2)
Not sure which fits? Take the 60-second quiz.