FriendlyARM NanoPi R1S H5: OpenWrt Compatibility Report
The FriendlyARM NanoPi R1S H5 runs OpenWrt 25.12.1 on the sunxi/cortexa53 target, and has been supported since 22.03.0. Its No WiFi wireless on the none driver rates fair for open-source driver support (0.50/1.0), installation is rated moderate, and it is no longer sold new.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the FriendlyARM NanoPi R1S H5, which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | Allwinner H5 |
|---|---|
| CPU | 4 cores @ 1250 MHz |
| RAM | 512 MB |
| Ethernet ports | 2 |
| USB | 1x 2.0, 1x µUSB (power) |
| WiFi generation | No WiFi |
| WLAN driver | none |
| OpenWrt target | sunxi / cortexa53 |
| Package architecture | aarch64_cortex-a53 |
| Current release | 25.12.1 |
| Supported since | 22.03.0 |
| Install method | Sunxi installation |
| Install difficulty | moderate |
| Power supply | 5 VDC, 2.0 A via USB Female Micro-B |
| Device type | Wired only |
| Estimated throughput | 1000 Mbps |
| Availability | discontinued |
Installing OpenWrt on the NanoPi R1S H5
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: Sunxi installation.
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
Deciso DEC740
Mellanox Spectrum SN3420
Mellanox Spectrum SN2700
Not sure which fits? Take the 60-second quiz.