Evaluation boards / unbranded boards Ralink V11ST-FE: OpenWrt Compatibility Report
The Evaluation boards / unbranded boards Ralink V11ST-FE was supported by OpenWrt from 15.05 on the ramips/rt288x target, but its last supported release has reached end of life. Its No WiFi wireless on the none driver rates fair for open-source driver support (0.50/1.0), installation is rated moderate, and it is no longer sold new.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the Evaluation boards / unbranded boards Ralink V11ST-FE, which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | Ralink RT2880F |
|---|---|
| CPU | 1 core @ 266 MHz |
| RAM | 32 MB |
| Flash | 4 MB |
| Ethernet ports | 4 |
| WiFi generation | No WiFi |
| WLAN driver | none |
| OpenWrt target | ramips / rt288x |
| Package architecture | mips_4kec |
| Current release | EOL |
| Supported since | 15.05 |
| Install difficulty | moderate |
| Device type | Wired only |
| Estimated throughput | 33 Mbps |
| Availability | discontinued |
Installing OpenWrt on the Ralink V11ST-FE
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload.
Official OpenWrt device page for the Ralink V11ST-FE
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
Deciso DEC740
Mellanox Spectrum SN3420
Mellanox Spectrum SN2700
Not sure which fits? Take the 60-second quiz.