D-Link DGS-1210-28MP: OpenWrt Compatibility Report
The D-Link DGS-1210-28MP runs OpenWrt 25.12.1 on the realtek/rtl838x target, and has been supported since 23.05.0. Its No WiFi wireless on the none driver rates fair for open-source driver support (0.50/1.0), installation is rated moderate, and it is still sold new.
Hardware data and retail listings last checked .
Where to buy
Some links are affiliate links. Learn more.
Specifications
| SoC | Realtek RTL8382M |
|---|---|
| CPU | 1 core @ 500 MHz |
| RAM | 128 MB |
| Flash | 32 MB |
| WiFi generation | No WiFi |
| WLAN hardware | - |
| WLAN driver | none |
| OpenWrt target | realtek / rtl838x |
| Package architecture | mips_4kec |
| Current release | 25.12.1 |
| Supported since | 23.05.0 |
| Install method | see git-commit |
| Install difficulty | moderate |
| Power supply | 100-240V, 50/60Hz via C13 |
| Device type | Wired only |
| Estimated throughput | 62 Mbps |
| Availability | available |
Installing OpenWrt on the DGS-1210-28MP
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: see git-commit.
Official OpenWrt device page for the DGS-1210-28MP
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Other routers to consider
Deciso DEC740
Mellanox Spectrum SN3420
Mellanox Spectrum SN2700
Not sure which fits? Take the 60-second quiz.