Cubitech CubieBoard1: OpenWrt Compatibility Report
The Cubitech CubieBoard1 runs OpenWrt 25.12.1 on the sunxi/cortexa8 target, and has been supported since 17.01.0. Its No WiFi wireless on the none driver rates fair for open-source driver support (0.50/1.0), installation is rated moderate, and it is no longer sold new.
Hardware data and retail listings last checked .
Where to buy
We have no current retail listing for the Cubitech CubieBoard1, which is no longer sold new. See current alternatives for devices you can still buy today.
Specifications
| SoC | Allwinner A10 |
|---|---|
| CPU | 1 core @ 1000 MHz |
| RAM | 1024 MB |
| Flash | 4096 MB (NAND) |
| Ethernet ports | 1 |
| USB | 2x 2.0, 1x OTG |
| WiFi generation | No WiFi |
| WLAN hardware | - |
| WLAN driver | none |
| OpenWrt target | sunxi / cortexa8 |
| Package architecture | arm_cortex-a8_vfpv3 |
| Current release | 25.12.1 |
| Supported since | 17.01.0 |
| Install method | Sunxi installation |
| Install difficulty | moderate |
| Power supply | 5 VDC, 2.0 A via barrel |
| Device type | Single-board computer |
| Estimated throughput | 175 Mbps |
| Availability | discontinued |
Installing OpenWrt on the CubieBoard1
Installation on this device is rated moderate. Expect to use a recovery mode, TFTP or a vendor tool rather than a plain web upload. Documented methods: Sunxi installation.
Official OpenWrt device page for the CubieBoard1
Flashing third-party firmware can brick a router and usually voids the warranty. Always check that the firmware image matches your exact hardware version.
Still sold and well supported
Deciso DEC740
Mellanox Spectrum SN3420
Mellanox Spectrum SN2700
Not sure which fits? Take the 60-second quiz.